Skip to content

Ipsaya IP Lookup Blog

  • Home
  • About Us
  • Write for Us
  • Contact
Ipsaya IP Lookup Blog
  • Reading Origin IPs in an Email Header
    Practical Lookups

    Reading Origin IPs in an Email Header

    ByIpsaya Editorial November 22, 2026November 15, 2026

    TL;DR / Summary: An email header records servers, not people. Read the receiving chain from the bottom upward, treat every address as a machine that handled the message, and match the address against a public lookup before drawing any conclusion about the sender’s location. What a header can and cannot prove Headers are a log…

    Read More Reading Origin IPs in an Email HeaderContinue

  • Double NAT at Home: Which Public IP Apps Actually See
    Ip Concepts

    Double NAT at Home: Which Public IP Apps Actually See

    ByIpsaya Editorial November 21, 2026November 15, 2026

    TL;DR / Summary: In a double NAT setup, two routers each run their own private network, and only the outer one holds the public address. Every device sees that same public IP, which is why lookups agree with each other and still fail to explain why incoming connections cannot find a machine inside. Two routers,…

    Read More Double NAT at Home: Which Public IP Apps Actually SeeContinue

  • Checking Public IP After a Router Firmware Update
    Ip Concepts

    Checking Public IP After a Router Firmware Update

    ByIpsaya Editorial November 20, 2026November 15, 2026

    TL;DR / Summary: Router firmware updates often reboot the WAN session and can hand you a new public IP. Before you assume remote access, VPN profiles, or camera apps are broken permanently, look up the current public address and compare it to what those services expect. Firmware night is a WAN event Updating router firmware…

    Read More Checking Public IP After a Router Firmware UpdateContinue

  • Checking Public IP Before API Allowlist Access
    Practical Lookups

    Checking Public IP Before API Allowlist Access

    ByIpsaya Editorial November 19, 2026November 15, 2026

    TL;DR / Summary: API allowlists fail when you paste yesterday’s public IP or the IP of a different network path. Look up the egress address from the same machine and route that will call the API, confirm IPv4 versus IPv6, and re-check after any VPN or office network change. Allowlists care about egress, not about…

    Read More Checking Public IP Before API Allowlist AccessContinue

  • Why Two Devices Share One Public IP Address
    Ip Concepts

    Why Two Devices Share One Public IP Address

    ByIpsaya Editorial November 18, 2026November 15, 2026

    TL;DR / Summary: Every device in your home shares one public address because a router performs network address translation. That is normal, it is why the internet works at all on IPv4, and it explains why a website cannot see your laptop directly. One address, many devices The provider assigns a single public address to…

    Read More Why Two Devices Share One Public IP AddressContinue

  • An IP Lookup After Switching to Mesh Wi-Fi
    Practical Lookups

    An IP Lookup After Switching to Mesh Wi-Fi

    ByIpsaya Editorial November 17, 2026November 15, 2026

    TL;DR / Summary: After switching to mesh Wi-Fi, your public IP should not change — unless the mesh unit is acting as a router and double-NATing. Check the address at the mesh node and at the modem to see where the translation happens. What should happen Your public address is assigned by the internet provider…

    Read More An IP Lookup After Switching to Mesh Wi-FiContinue

  • A Phone Reboot That Moves Your City Lookup
    Practical Lookups

    A Phone Reboot That Moves Your City Lookup

    ByIpsaya Editorial November 16, 2026November 15, 2026

    TL;DR / Summary: A phone that reboots and then appears in a different city is usually being assigned a new address from a pool, not being mislocated. Mobile networks rotate addresses and route traffic through regional gateways, so the city label is a hint rather than a fact. What a reboot changes When a phone…

    Read More A Phone Reboot That Moves Your City LookupContinue

  • IPv4 and IPv6 Preference Producing Different Results
    Ip Concepts

    IPv4 and IPv6 Preference Producing Different Results

    ByIpsaya Editorial November 15, 2026November 15, 2026

    TL;DR / Summary: When an IP lookup shows one address on one device and a different one on another, the cause is usually IPv4 versus IPv6 preference, not a network fault. Check both protocol families before assuming something is wrong. Two addresses, one connection A modern network connection has both an IPv4 address and an…

    Read More IPv4 and IPv6 Preference Producing Different ResultsContinue

  • Carrier-Grade NAT Signs on Residential IP Lookups
    Ip Concepts

    Carrier-Grade NAT Signs on Residential IP Lookups

    ByIpsaya Editorial November 14, 2026November 11, 2026

    TL;DR: If inbound connections fail, open ports on your router do nothing, and your public IP is shared with strangers, you may be behind carrier-grade NAT (CGNAT). Confirm the WAN address your modem shows versus what an IP inquire page reports, then plan allowlists and hosting accordingly. What CGNAT changes about “my public IP” Classic…

    Read More Carrier-Grade NAT Signs on Residential IP LookupsContinue

  • Split-Tunnel VPN: Which Egress IP Support Actually Sees
    Practical Lookups

    Split-Tunnel VPN: Which Egress IP Support Actually Sees

    ByIpsaya Editorial November 14, 2026November 11, 2026

    TL;DR: Split tunneling sends only some traffic through the VPN. Your browser’s public IP check may show the tunnel while a vendor’s API still sees your ISP—or the reverse. Capture both paths with an IP inquire lookup before you open a “please allowlist my IP” ticket. Full tunnel versus split tunnel in one sentence Full…

    Read More Split-Tunnel VPN: Which Egress IP Support Actually SeesContinue

Page navigation

1 2 3 4 Next PageNext

Copyright © 2026 Ipsaya

  • Home
  • About Us
  • Write for Us
  • Contact